Gap Between Edge Of Roof And Edge Of Gutter

If the gutter is lower than the bottom edge of the drip edge install flashing behind the drip edge and over the back edge of the gutter to remove the gap.

Gap between edge of roof and edge of gutter.

Home centers sell rolls of 6 in. Drip edge flashing directs roof runoff away from the roof fascia and edge and into gutters or at least not down the fascia board if no gutters are installed and it is recommended by roofing standards manufacturers and experts. When you choose a reliable roofing contractor you can feel confident that you are getting the work done right the first time. For gutters to work properly they must be properly sloped toward the downspouts and the roof must have a drip edge that clears the sides of the gutters closest to the house.

The gutters are getting old and i want to replace all. Other than being old and rusty they are working fine based on my obser. What are some solutions to cover the gap between the roof deck and the fascia board. I have gutters all the way around shingles overhang 1 1 5 get good flow to gutters.

If there s a drip edge installed where the fascia meets your shingles and the gutter is hung below the drip edge get some roll flashing and tuck it up under the drip edge and over the top of the gutter. Once up the ladder i was able to see the new guttering fascia installation done about 18 months old close up for the first time and i m worried about it. The 3 would be the distance measured from the drip edge the point at which the water falls from the roof to the top of the gutter. I recently had roof replaced and did not have drip edge installed.

My issue since not on contract and i did not check life lesson. You must have some odd water where you are if it flows up hill. Does not address our recommended best practice of drainage gap for drip edge installation on roofs. Since the gutters have to slope down towards the downspout this distance will increase as you get closer to the downspout.

Once the apron s in place fasten it with sheet metal screws. Looking right down the line of the guttering the gap between the end of the last roof tile and the outer edge of the guttering varies from around an inch and half to in some cases millimetres.