Gap Between Gutter And Fascia Board

Subtract 1 32 inch for every 10 feet of gutter and then note down the new total at the bottom end of the gutter run.

Gap between gutter and fascia board.

There is a gap between the gutters and the fascia. When it rains water pours through that gap and splashes on the window screens. Surely this is not how it should be. The gutters are getting old and i want to replace all.

Other than being old and rusty they are working fine based on my obser. When water drips between the fascia and the gutters the problem could be a compromised drip edge but it s also possible the gutters are overflowing. I don t have gap all around just in some areas. Gap between gutters and fascia board how easy is this to fix.

Upon closer inspection it was obvious that there was a large gap that had developed. The fascia is the wide board that s installed on edge and runs horizontally along the edge of the roof. Making the tops of your fascia boards the same angle as the roof allows you to easily place roofing material over them without creating bumps or ridges. Measure the distance from this nail to the bottom of the fascia board.

The soffit is the flat panel that covers the underside of the rafters between the back of the fascia and the outside of the house wall. I just got a new roof new siding and new gutters. Set the angle of the circular saw blade to match the slope of your roof and run the saw along the top edge of each fascia board. I can see sky when i stand under the gutter and look straight up.

What are some solutions to cover the gap between the roof deck and the fascia board. I recently had roof replaced and did not have drip edge installed. Rip the tops of the fascia boards to match the slope of your roof. I have gutters all the way around shingles overhang 1 1 5 get good flow to gutters.

For gutters to work properly they must be properly sloped toward the downspouts and the roof must have a drip edge that clears the sides of the gutters closest to the house. Drive a nail at this spot and then snap a chalk line between the two nails. I have a 30 year old house which i have owned for the last five years. Smooth the caulk bead with your finger and begin caulking the joint between the fascia board and the soffit.

My issue since not on contract and i did not check life lesson. Its top edge is tucked up under the shingles and its outside face is where the gutter is mounted.